Equus 3120 - OBD 2&1 Tool Kit Manuel d'utilisateur télécharger pdf (Page 83)

OBD2 & 1 81

Erasing DTCs

■ If the erase was not successful, an

advisory message shows on the LCD

display.Verify that the Tool is proper-

ly connected to the vehicle's DLC

and that the ignition is ON. If the

erase process still does not com-

plete, turn the ignition OFF, wait 10

seconds, then turn back ON and repeat steps 2 and 3.

FORD systems will not display an erase was not successful

message.If the “One moment please erase in progress”mes-

sage on the display does NOT change after 3 minutes, it indi-

cates that the erase function has failed. Check the DLC con-

nections and make sure the ignition key is “ON”. Perform the

ERASE function again.

Erasing DTCs does not fix the problem(s) that caused the

code(s) to be set.If proper repairs to correct the problem that

caused the code(s) to be set are not made, the code(s) will

appear again and the check engine light will illuminate as

soon as the problem that cause the DTC to set manifests

itself.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88

Pas de commentaire

Equus 3120 - OBD 2&1 Tool Kit Manuel d'utilisateur Page 83