Equus 3140 - Scan Tool CanOBD2&1 Kit Manuel d'utilisateur télécharger pdf (Page 10)

About the CanOBD2&1 Scan Tool

ADJUSTMENTS/SETTINGS AND DTC LIBRARY

8 CanOBD2&1

If a definition for the DTC you

entered is not available, an advi-

sory message shows on the

CanOBD2&1 Scan Tool’s display.

4. If you wish to view definitions for addi-

tional DTCs, press the ENTER/LD

button to return to the DTC Library

screen, and repeat steps 2 and 3.

5. When all desired DTCs have been viewed, press the ERASE

button to exit the DTC Library and return to the Setup Menu.

Selecting the Display Language

1. Use the UP and DOWN buttons, as necessary, to highlight

Select Language in the Setup Menu, then press the ENTER/LD

button.

■ The Select Language screen dis-

plays.

■ The currently selected display

Language is highlighted.

2. Press the UP or DOWN button,

as necessary, to highlight the desired

display language.

3. When the desired display language is

highlighted, press the ENTER/LD

button to save your changes and return

to the Setup Menu.

Setting the Unit of Measurement

1. Use the UP and DOWN but-

tons, as necessary, to highlight Unit of

Measure in the Setup Menu, then

press the ENTER/LD button.

2. Press the UP or DOWN button,

as necessary, to highlight the desired

Unit of Measure.

3. When the desired Unit of Measure

value is selected, press the ENTER/LD

button to save your changes and

return to the Setup Menu.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 111 112

Pas de commentaire

Equus 3140 - Scan Tool CanOBD2&1 Kit Manuel d'utilisateur Page 10